SpectraPANEL X200 200W LED Grow Light - Full Spectrum for 100x100 Tents | BloomLED

SpectraPANEL X200: the 200W LED grow light built for a 100x100 tent

Running a 100x100 tent and looking for a light that takes your plants from cutting to harvest without compromise? The SpectraPANEL X200 was built for exactly that. This 200 W LED grow panel delivers a full spectrum calibrated for vegetative growth and flowering, with an efficacy of 2.6 µmol/J that puts roughly 520 µmol/s of usable light above your canopy. Its cooling is entirely passive, which means no noise, no vibration, and no moving part waiting to fail two cycles in. At BloomLED, LED horticultural lighting specialists for over 10 years, we design our panels in France around one simple idea: a grower should never have to choose between performance, reliability and peace and quiet.

A full spectrum designed for the entire cycle

Plenty of budget LED fixtures force you to buy a second light the moment you flip to 12/12. The SpectraPANEL X200 combines Samsung TOP BIN white diodes with LEDStar 660 nm deep red diodes spread across 220 emission points. The result is a continuous spectrum with no gaps in the PAR range, feeding photosynthesis during veg just as effectively as it drives flower development at the end of the cycle.

In practice, you keep the same fixture from cutting to harvest. The TOP BIN whites supply the blue and green needed for compact structure and short internodes, while the 660 nm deep red targets the absorption peak of chlorophyll a and pushes flowering. No second purchase, no rewiring, no mid-run compromise.

The 120° beam angle and the distribution of diodes across the whole panel surface deliver a uniformity that concentrated COB fixtures simply cannot match. Plants at the edges of your tent receive an intensity comparable to those in the centre, which is exactly what separates a good yield from a disappointing one in a 100x100.

Absolute silence: fully passive cooling

This is where the SpectraPANEL X200 breaks away most sharply from the competition. Where almost every 200 W panel on the market carries one or two fans, ours dissipates all of its heat through a solid aluminium heatsink. No fan, no decibels, no wear part.

That changes three things. Comfort first: if your tent sits in an office, a living room or a bedroom, you will hear absolutely nothing from the light. Reliability second: the fan is statistically the first component to fail on an LED grow light, and there simply isn't one here. And cleanliness third: no fan means no dust being pulled in and no heatsink clogging cycle after cycle.

The panel body stays lukewarm to the touch under continuous operation, which limits parasitic heat load in your space and makes it far easier to hold the 20-25 °C range that keeps plants clear of heat stress.

Control, ingress protection and installation

The dimmer is built in as standard: you adjust intensity directly on the fixture, with no extra accessory to buy. A freshly rooted cutting does not have the same light requirements as a plant in full bloom, and being able to dial the power back during the first weeks prevents bleaching and light stress.

For growers who want to go further, the X200 supports 0-10 V and PWM protocols as well as the SmartWILD control console (sold separately). From there you can automate gradual sunrise and sunset ramps, drive several fixtures in parallel and schedule your cycles without ever touching the hardware.

On the durability side, the IP65 rating protects the electronics against humidity and water splashes — genuinely useful in a grow space where relative humidity regularly climbs past 60 % and foliar spraying is part of the routine. At 405 x 305 x 77 mm in a flat panel format, installation takes minutes at the recommended 40 cm above the canopy.

Full technical specifications

Why choose the SpectraPANEL X200?

Frequently asked questions