Turn your irrigation line through 90°. — This female/female compression elbow joins two 16 mm PE pipes leak-free, with no glue and no tools.
Hand-picked by BloomLED, indoor growing expert for over 10 years, designed in France.
Compression FF · Ø 16 mm · 90° angle · Leak-proof · Reusable
Need to route your line around a tent pole, an upright or the corner of a grow table without kinking the pipe? The 16 mm compression elbow joins two PE (polyethylene) pipes at 90° for a perfectly smooth flow of water and nutrients. Female/female, it fits in seconds with no glue and no tools, and stays watertight even under pressure.

| Specification | Detail |
|---|---|
| Fitting type | 90° compression elbow |
| Connection | Female / Female (FF) |
| Diameter | 16 mm (PE pipe outer Ø) |
| Material | High-strength plastic |
| Sealing | Compression ring, tool-free |
| Use | Drip irrigation, hydroponics, outdoor |
Push the 16 mm PE pipe into each end and tighten the compression ring by hand: the fitting locks tight and fully sealed. No gluing, no wrench needed.
The compression ring grips the pipe all the way around 360° and withstands the pressure of your pump or mains feed, drip-free season after season.
Perfect for shaping a drip network inside a tent, greenhouse or flood table: route around corners and make the most of every metre of pipe.
This elbow is made for 16 mm outer-diameter semi-rigid PE (polyethylene) pipe, the standard for indoor and garden irrigation networks.
Is the fitting reusable?Yes. Loosen the compression ring to release the pipe and rebuild your circuit elsewhere: the fitting can be reused without losing its seal.
A reliable irrigation network starts with fittings that never let go: BloomLED compression gives you clean corners and a 100% watertight seal.